ACC Silicones manufacture a variety of additives for use with our silicone elstomers. They can be used to control cure speeds, rehology, hardness and other physical properties of the cured rubber.
These can be used as diluents to reduce viscosity of an uncured material or lower the hardness of the cured elstomer. Specially formuated fluids with the addition of UV pigents are used with our range of RTV conformal coatings.
Silicone fluids are regularly used in the manufacture of special effects, prosthetics and Tampo printing pads.
We produce a range of catalysts matched for use with our condensation cure moulding rubbers to provide control over cure speeds and pot life. Booster cataysts can be used to speed up cure profiles. A thixotroping agent will allow a normally pourable rubber to be applied by knife or brush to vertical surfaces.
|ACC31||Thinners for ACC 11 acrylic conformal coating|
|ACC34||Low viscosity fluid for thinning 1 part RTV's|
|CA28||Tin catalyst (for use with ACC Silicones 2 Part encapsulants)|
|MM Cat B5 NT||Tin Catalyst standard cure speed, blue|
|MM Cat L5 NT||Tin Catalyst low tear for leather reproduction|
|MM CAT L6W NT||Tin catalyst high tear, clear|
|MM CAT R5 NT||Tin Catalyst fast cure speed, red|
|MM Cat VE NT||Tin catalyst for shoe moulds standard cure|
|MM Cat VEI NT||Tin catalyst for shoe moulds fast cure|
|MM Cat W||Tin catalyst booster for rapid cure|
|MMTA2||Thixotroping additive for condensation cure moulding rubber|